Poured liners
Cast in place liners are formed inside the old chimney with a heat resistant mix in a single solid lining.
A sweep in Northbrook can reline an unlined or damaged flue with a liner sized to the appliance and insulated where the system calls for it. Call (224) 458-2675 to reach a local chimney sweep.
The liner is what smoke travels through on its way out of the house. It keeps heat from reaching wood framing next to the chimney, protects the brick and mortar from corrosive gases and gives the appliance a flue of the right size to draft well. Some older chimneys were built unlined, and others have clay tiles that have cracked over the decades.
Most liner installations start with one of these situations. Clay tiles crack after chimney fires, shift as the house settles and lose mortar at the joints, while some chimneys never had tiles to begin with. Installing an insert, stove or high efficiency furnace often means the old flue is the wrong size.
Industry standards based on NFPA 211 call for a Level 2 inspection when an appliance is changed or after a chimney fire. It helps decide between repair and relining, and between flexible and rigid stainless. Ask to see the camera video so you understand what was found.
Chimney Liner Installation is often paired with chimney liner repair and chimney inspection, depending on the cause.
Looking for Northbrook chimney liner installation? Call (224) 458-2675 to talk to a local chimney sweep.
Call nowHere is how a sweep usually handles a liner installation.
The inside of the chimney is checked so the route and condition are known. The findings shape the rest of the job.
The liner diameter is matched to the appliance outlet or the fireplace opening, following the manufacturer guidance. The route and any offsets are noted.
The flue is swept and any loose tile or obstruction is cleared so the liner can pass. Some chimneys need old tiles broken out to fit an insulated liner.
The stainless liner is lowered from the roof down to the appliance, often wrapped in an insulation blanket. Many liner systems are tested with insulation for clearance to combustibles.
At the top, a plate and cap close off the flue, and at the bottom the liner connects to the appliance. A sealed system is the whole point of relining.
The sweep checks the draft and looks for any leaks. Make sure working CO alarms are in place near sleeping areas.
Cast in place liners are formed inside the old chimney with a heat resistant mix in a single solid lining.
Flex liners snake through chimneys with bends and offsets which makes them the most common relining choice.
Insulation is wrapped around the liner or poured into the space around it where the system or chimney calls for it.
Straight flues can take rigid stainless pipe and holds up to frequent cleaning.
Smaller liners for gas or oil furnaces and water heaters to keep combustion gases moving out of the house.
A stainless steel liner is the standard choice for most homes that need a new flue. Flexible liners make it possible to reline chimneys with offsets, while rigid pipe gives a smooth, heavy wall. The sweep picks a grade of stainless that suits the fuel the appliance burns.
Insulation around the liner helps flue gases rise and keeps the outside of the chimney cooler. The top of the liner is sealed with a plate and covered with a cap. Homeowners in Northbrook often choose stainless when adding an insert, stove or new furnace.
Relining means putting a new liner into a chimney that has an old, damaged or missing one. It is often recommended after a chimney fire, when clay tiles crack, or when a new appliance needs a different flue size. Most chimneys can be relined from the roof without opening walls.
When you call (224) 458-2675, tell the sweep what vents into the chimney, such as a fireplace, stove, furnace or water heater. If the furnace was upgraded recently, the water heater may now be venting into a flue that is too large. A smaller liner brings the draft back where it should be.
In Northbrook, older homes often have unlined chimneys or clay tiles that have cracked with age. Homes in Northbrook and neighboring towns like Deerfield, Glenview, Northfield and Glencoe often switch to inserts, stoves or high efficiency furnaces, which changes what the flue needs, so it is worth having the flue inspected before the next heating season.
Need chimney liner installation around Northbrook? Call (224) 458-2675 for a Northbrook chimney sweep who serves the towns around it too.
This part of the country gets long winters, heavy snow in places and stretches of bitter cold. Heating systems and wood stoves work nearly nonstop for months, so flues collect creosote fast and liners and crowns see a lot of heat and cold. Snow drifting against the back of a chimney melts slowly and works water under tired flashing. That is why Northbrook chimney sweeps are busiest every September and October.
Small chimney problems caught early usually stay small repairs.
Chimney sweeps in Northbrook know the chimneys and fireplaces common in local homes.
Ask your questions before you agree to anything.
More questions? Call (224) 458-2675
Restoring a damaged chimney liner so smoke and gases stay sealed inside the flue.
Learn moreAn annual look at the flue, firebox, damper, crown and cap to catch cracks, blockages and leaks before they turn into hazards.
Learn moreInsert installation for drafty, inefficient open fireplaces, with the chimney inspected before anything goes in.
Learn moreInstalling freestanding wood stoves with the right clearances, hearth and venting, so the stove drafts well and stays clear of anything that can burn.
Learn moreLooking for something else?
See all chimney servicesCall now for Northbrook chimney liner installation and help in the towns around it.
Free to call. No forms to fill out.